ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 78)

Appendix
Bonito Technical Manual V2.3.0
78
All other values are reserved.
T= : Trigger source selection.
0: None.
2: OK1 at control connector.
3: CC1 at O2 connector (or CL1).
4: CC1 at O4 connector (if available).
All other values are reserved.
U= : Metadata overlay and test image.
<***t_***m>
| |
| +-m: Metadata overlay mode.
| 0: No overlay.
| 1: Show metadata in each frame starting at
| the first pixel of the first line.
+------t: Test image generator.
0: Normal image output.
1: Test image generator is active.
V=1 : Show model and firmware version information. Use V=2 for a
more detailed output.
W= : Dark value offset. This value is added to the pixel data. It
is used to adjust the dark level and avoid clipping of pixels
to black in low light situations. The eight bits are aligned
to the lowest significant bit of the 10-bit raw pixel data
from the sensor. if the digital gain is not active
(G=0), each increment of four increases the output grey level
just for one count.
X=1 : Store the current parameter configuration to the flash.
Y=1 : Show the current parameter configuration.
Z=1 : Load the factory default parameter configuration. The
saved configuration is only affected if you store the reset
parameter values with X=1 afterwards.