ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 38)

Parameters and commands
Bonito Technical Manual V2.3.0
38
Parameters and commands
This section explains the basic Bonito configuration parameters and general
commands available to the user. Parameters and commands are communicated
using the camera’s serial interface. For more information see chapter
Serial I/O
on page 22.
Primary starting address (A)
The parameter A defines the line address of the image sensor that is the first
line of the output image. The value of A in conjunction with N and I is used to
create a region of interest (ROI1).
Range From 0 (topmost line) to 6BD (lowermost line)
Default 0
Related Parameters B, D, N and I
Example A=35E (0x35E = 862), first line at address 862, that is the 863
rd
line of the
sensor
N=F read 16 lines
I=2 read every second line
Note

In this section, all values and examples noted in mono-
spaced font are denoted in the hexadecimal numbering
system, if not otherwise noted.
In all cases, explicit base notation (e.g. 0x4711 or 045H) is
omitted to be directly compatible to the camera's command
interface syntax.
Example: to set M to the value of M=0x21,
use the command M=21.
Note

For more information on double ROI mode and a diagram dis-
playing the ROI parameters, see chapter
Double region of
interest mode (D) on page 40.
Each image sensor line can only be read once per exposure. Two
ROIs are only possible as long as they do not share the same
line addresses.