ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 48)

Parameters and commands
Bonito Technical Manual V2.3.0
48
• Activates Image on demand mode (IOD) with exposure timer (weight = 2)
• Deactivates PIV mode (weight = 0)
• Activates Permanent exposure mode (weight = 20)
M=2A
(0x2A = 0b101010. This value is not recommended since bit #3 is set to
1 here,
even though it is not used by the parameter.)
Sets the bit field to „- - 1 0 - 0 1 0“
• Activates Image on demand mode (IOD) with exposure timer (weight = 2)
• Deactivates PIV mode (weight = 0)
• Activates Permanent exposure mode (weight = 20)
Exposure timing mode (bit group e)
The exposure timing mode allows to switch between the continuous mode and
three different IOD modes.
Continuous mode
Bit group: e
Value: 0
The camera outputs images as fast as possible in free-running mode.
The gap between two images is only one line, the total frame duration takes
t
FDmin
. The exposure time is nearly equal to this inherent minimal frame dura-
tion.
Image on demand mode (IOD)
Bit group: e
Value: 1
The exposure is triggered by an external signal.
Use parameter T to select the signal source. A rising edge starts exposure syn-
chronizing to the line after the next line.
Weight
(hexadecimal) Setting
0 Continuous mode
1 Image on demand mode (IOD)
2 Image on demand mode (IOD)
with exposure timer
3 Image on demand mode (IOD)
with exposure timer and frame duration timer
Table 12: Exposure timing mode - possible values