ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 62)

Parameters and commands
Bonito Technical Manual V2.3.0
62
Metadata overlay and test image generator (U)
The Bonito can overlay the image’s first pixels with some bytes of metadata,
such as a hardware frame counter. The frame counter increments for each image
read out from the sensor. This helps to increase system reliability by detecting
missing frames on the host system. In dual channel mode (
S=1 or S=3) it can
also be used to join the two related image halves because they have the same
counter value.
Furthermore, to test the Camera Link cabling and frame grabber operability, a
test image generator is available. It forces the camera to output an almost fixed
test image containing grey wedges, black and white stripes with various fre-
quencies and edge markers.
Range Either 0, 1, 10, or 11
Default 0
Related Parameters C, D, G, N, and M
Examples (see settings table below.)
Setting Function
T=0 No input selected.
T=2 Optocoupler OK1 at pins 10 and 11 of the control connector.
T=3 CC1 at the Camera Link connector O2 or CL1 (default).
T=4 CC1 at the Camera Link connector O4.
(Others) Reserved for future use.
Table 23: Trigger source selection (T)
Note

For more information:
see chapter
Trigger input (pin 10-11) on page 27
and chapter Trigger inputs (CC1) on page 32.
Setting Function
U=0 Normal image output.
Table 24: Trigger source selection (T)