ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 72)

Appendix
Bonito Technical Manual V2.3.0
72
z=1 : Reload parameters from file. (*)
O= : File number of the file containing the FPGA configuration
data. (*)
P=1 : Upload a new FPGA configuration file via the serial
interface and store it in the flash memory. After issuing
a special transfer protocol is processed. A currently
existing file will be overwritten. (*)
Q= : Upload a general file via the serial interface and store
it in the flash memory using the specified file number.
After issuing a special transfer protocol is processed.
A currently existing file will be overwritten. (*)
Command and Parameter Overview - User Mode (Lower Case)
-------------------------------------------------------
p= : Internal system parameter. Change this setting only if you
know what you are doing!
\_______| \_______|
| +---c: Camera Link clock phase. Modify
| this byte value a few steps up or
| down to optimize the phase of the
| Camera Link clock. It may
| eventually improve data
| transmission reliability with
| long cable runs in some cases.
+-------------s: Internal system parameter. Do not
change this byte at all. To modify
the other bitfield "c" please first
read all bits of p= from the
camera, modify only the bits of "c"
and write back the complete value
including the "s"-bits unchanged.
s= : Configure the UART(s) for serial communications. Changes are
activated immediately.
|\| \__|
| | +---b: Baud rate of the main RS-232 UART available
| | at the 15-pin D-sub connector and the second
| | channel UART via Camera Link. The second
| | channel UART supports 9600 to 115200 Baud
| | only (x). Both channels share the same
| | receive buffer and output characters are
| | always sent to both. the two channels
| | are not intended for completely concurrent
| | use.
| | 0 -> 110 Baud.
| | 1 -> 300 Baud.
| | 2 -> 600 Baud.
| | 3 -> 1200 Baud.
| | 4 -> 2400 Baud.
| | 5 -> 4800 Baud.
| | 6 -> 9600 Baud. (x)