ALLIED Vision Technologies Bonito CL-400 200 fps - Manual (Page 60)

Parameters and commands
Bonito Technical Manual V2.3.0
60
Camera Link output mode setting (S)
The parameter S controls how the camera outputs pixel data to the Camera Link
interface.
• For more information about how the resulting image is reconstructed in
the various modes, see chapter
Pixel order on page 33.
• For more information about pixel output timing, see chapter Timing
(FVAL, LVAL, PCLK) on page 35.
Valid values: Either 0, 1, 3, 5, or 7
Default 0
Related Parameters s, T
Examples (see settings table below.
Note

• Consider the number of lines in minimum frame duration
calculations for the image on demand (IOD) mode.
• For more information about calculation of the minimum
frame duration and dependent IOD mode timing con-
straints, see chapter
Exposure control mode (M) on page
45.
Setting Function
S=0 • Mode: Single channel mode
• Frame rate: 193 fps
• Line length: 2320 pixels
• The camera utilizes one Camera Link 80-bit channel in 10-
tap configuration. It allows only half of the maximum frame
rate but also produces less noise in the image because the
sensor clock frequency is reduced.
(To be continued on next page.)
S=0 (Continued from previous page.)
The preferred Camera Link connector pair for this mode is the left
channel O2 / O1, but the other pair (O4 / O3) also outputs all
pixel data. The CC signals and SerTC / SerTFG are handled sepa-
rately per channel. That means for example the trigger source
selection (
T) and serial port configuration (s) might need
adjustments if O4 / O3 are used. The Bonito CL-400B/C 200fps
provides only one channel at the connectors CL1/CL2.
Table 22: Camera Link output settings.