DE-STA-CO IM-pAC AC Drive Getting Started Guide - Manual (Page 66)

66 IM-pAC Getting Started Guide
www.camcoindex.com | www.destaco.com Issue Number: 5
7.3 Parameter descriptions - Level 3
Set Pr 71 to Pr 80 to the required advanced parameter number to be accessed.
The value within these parameters will be displayed in Pr 61 to Pr 70. Pr 61 to Pr 70 can
then be adjusted to change the value within a parameter.
7.4 Diagnostic parameters
The following read only (RO) parameters can be used as an aid to fault diagnosis on the
drive. See Figure 8-1 Diagnostics logic diagram on page 68.
No Function Range Defaults Type
71
to Pr 61 to Pr 70 set up 0 to Pr 21.51 RW
80
No Function Range Type
81 Frequency reference selected ±Pr 02 Hz RO
82 Pre-ramp reference ±Pr 02 Hz RO
83 Post-ramp reference ±Pr 02 Hz RO
84 DC bus voltage 0 to Drive maximum VDC RO
85 Motor frequency ±Pr 02 Hz RO
86 Motor voltage 0 to Drive rating V RO
87 Motor speed ±9999 rpm RO
88 Motor current +Drive maximum A RO
89 Motor active current ±Drive maximum A RO
90 Digital I/O read word 0 to 95 RO
91 Reference enabled indicator OFF (0) or On (1) RO
92 Reverse selected indicator OFF (0) or On (1) RO
93 Jog selected indicator OFF (0) or On (1) RO
94 Analog input 1 level 0 to 100 % RO
95 Analog input 2 level 0 to 100 % RO