DE-STA-CO IM-pAC AC Drive Getting Started Guide - Manual (Page 14)

14 IM-pAC Getting Started Guide
www.camcoindex.com | www.destaco.com Issue Number: 5
1.19 Drive parameter list for using a potentiometer to control
speed with a proximity switch for cycling
The speed range of the potentiometer is from 0 to the Pr 02 value.
T1 T2 T3 T4 T5 T6
B1 B2 B3 B4 B5 B6 B7
Drive enabled (normally closed)
Stop signal switch on camshaft
(normally closed)
Momentary Start
Radio Shack Pt.No 275-324
IMC Pt.No 87C08062019510
Radio Shack Pt.No 275-609
Single turn wire-wound potentiometer 2K to 10 KΩ (2W)
A project box 5 x 2-1/2 x 2 Radio Shack Pt.No 270-1803
can be used to house the switches and the potentiometer
NOTE
Parameter Description Value Units
Pr 01 Minimum set speed 0 Hz
Pr 02 Maximum set speed 60 Hz
Pr 03 Acceleration rate 1 0.1 s/100Hz
Pr 04 Deceleration rate 1 0.2 s/100Hz
Pr 05 Drive configuration 1:Av.Pr
Pr 06 Motor rated current - A (from motor plate)
Pr 07
Motor rated full load rpm 0 RPM (always 0)
Pr 08 Motor rated voltage - V (from motor plate)
Pr 09 Motor rated power factor - (from motor plate)
Pr 10
Security status 0:L1
Pr 11 Start / stop logic select 0
Pr 12 Brake controller enable 0:dis
Pr 15
Jog reference 1.5 Hz
Pr 16
Analog input 1 mode
(terminal T2)
6:VoLt