B&K Precision 4052-4055 - Manual - Manual (Page 20)

20
StopFreq/FrqSp
an
Configures the sweep stop frequency or the frequency span of
the sweep output.
StartFreq/MidF
req
Configures the sweep start frequency or the center frequency.
Source Selects the sweep source.
Trig Out/Edge Internal source: Selects to output a trigger signal at the start
of a sweep operation.
External source: Selects to use rising or falling edge from an
external trigger for sweep operation.
Linear/Log Selects between linear or logarithmic sweep operation.
Direction Selects the sweep direction
Trig Manually triggers the sweep operation if the source is set to
manual.
Burst
Period Configures the burst period.
StartPhase Configures the start phase of the burst output.
Ncycle/Gated Selects to burst by number of cycles or selects for external
gated burst.
Source/Polarity Selects the source for burst output or selects the polarity for
external gated burst output.
Trig Out Selects signal triggering on rising or falling edge.
Cycles/Infinite Configures number of cycles for burst or infinite burst
(external source only).
Delay Configures the delay of each burst.
Store/Recall
FileType Selects the type of files for save/recall.
Browser Selects to browser through folders or files on display.
Save Saves the selected file into internal or external USB flash
memory.
Recall Recalls the selected file from internal or external USB flash
memory.
Delete Select to delete the selection.
Utility
DC Selects to toggle ON/OFF a DC output. Selectable DC voltages
are: 1 V, -1 V, 2 V, -2 V, 5 V, -5 V.
Interface Selects the remote interface. .
Output Setup Load – Select output impedance.
Normal/Invert – Select to toggle between normal and
inverted output.
CHCopy – Copy channel settings between channels.
Sync – Select to enable/disable synchronization output with
respect to either channel 1 or 2.
Counter Selects built-in counter function.
System Access to system settings.
Test/Cal Built-in self test and adjustment options.
EditInfo Shows information about the generator.
Update For firmware updates.
Help