Autel MaxiDAS DS708 - Manual (Page 45)

39
3.2.2. Erase Codes
After reading and / or reviewing the diagnostic trouble codes, use the
following steps to erase the codes from the vehicle. If Erase Codes is not an
available menu option, consult the manufacturer’s service manual for the
correct “clear code” method.
NOTE: This Erase Codes function clears the DTCs from the selected
ECU or provides instructions for how to manually clear the codes from
the ECU.
NOTE: Before performing this procedure, make sure the vehicle’s
ignition key is in the On (Run) position with the engine off.
To Erase DTCs, please follow these steps:
1. With the Function Menu screen displayed, click on Erase Codes. This
displays an instruction screen.
2. Follow the instructions on each screen that appears until the procedure is
complete.
3. When finished, use the Esc button to return to previous screens.
4. Check the codes again. If any codes remain, repeat the Erase Codes steps.
3.3. Live Data
The Live Data function allows you to view live data from a vehicle’s
electronic control unit (ECU). This section describes how to use the Live
Data function.
3.3.1 Basic Live Data Procedure
To use the Live Data function, please follow these steps:
1. Follow the instructions in Section 3.1 Test Startup and Vehicle
Connection to display the Function Menu screen.