Atec Agilent-E5071B - Manual (Page 33)

33
Table 3-3 Control line
Description Specification Typical
Number of groups 4
Group A: 8 bits
Group B,C,D: 4 bits
Input voltage range 1 0 V to +5 V (positive input)
–5 V to 0 V (negative input)
Maximum current Group A, B: 50 mA in total of each group
Group C, D: 500 µA in total of each group
Impedance Group A, B: < 10 ohm
Group C, D: < 200 ohm
Table 3-4 DC source
Description Specification Typical
Number of sources 4
Output voltage range 0 V to +5.2 V (nominal) 2
Output voltage accuracy ±3 % of setting (+1 V to +5 V) at
1 M ohm load impedance
Voltage resolution 10 mV (nominal) 3
Maximum current 150 mA for each source
Output impedance < 5 ohm
Table 3-5 Operating storage environment
Description General characteristics
Temperature +5 °C to +40 °C
Humidity 20 to 80% at wet bulb temperature < +29 °C (non-condensing)
Altitude 0 to 2,000m (0 to 6,561 feet)
Vibration 0.21 G max., 5 to 500 Hz
Table 3-6 Non-operating storage environment
Description General characteristics
Temperature –10 °C to +60 °C
Humidity 20 to 90 % at wet bulb temperature < +40 °C (non-condensing)
Altitude 0 to 4,572 m (0 to 15,000 feet)
Vibration 0.5 G max., 5 Hz to 500 Hz
1 Input voltage will be clipped at about ±5.2 V when over this range.
2 The output voltage can be set in this range.
3 The output voltage resolution becomes effective between 0 V to 5.2 V.