Atec Agilent-E5071B - Manual (Page 3)

3
Corrected system performance
The specifications in this section apply for measurements
made with the Agilent E5070B/E5071B network analyzer
with the following conditions:
• No averaging applied to data
• Environmental temperature of 23°C ± 5°C, with less
than 1°C deviation from the calibration temperature
• Response and isolation calibration not omitted
Table 1-1 System dynamic range 1,2
Description Specification Supplemental information
System dynamic range
300 kHz to 3 MHz, IF bandwidth = 3 kHz 85 dB
3 MHz to 1.5 GHz, IF bandwidth = 3 kHz 95 dB 98 dB
1.5 GHz to 3 GHz, IF bandwidth = 3 kHz 97 dB 100 dB
3 GHz to 4 GHz, IF bandwidth = 3 kHz 96 dB 99 dB
4 GHz to 6 GHz, IF bandwidth = 3 kHz 92 dB 94 dB
6 GHz to 7.5 GHz, IF bandwidth = 3 kHz 87 dB 90 dB
7.5 GHz to 8.5 GHz, IF bandwidth = 3 kHz 80 dB 83 dB
300 kHz to 3 MHz, IF bandwidth = 10 Hz 110 dB
3 MHz to 1.5 GHz, IF bandwidth = 10 Hz 120 dB 123 dB
1.5 GHz to 3 GHz, IF bandwidth = 10 Hz 122 dB 125 dB
3 GHz to 4 GHz, IF bandwidth = 10 kHz 121 dB 124 dB
4 GHz to 6 GHz, IF bandwidth = 10 Hz 117 dB 119 dB
6 GHz to 7.5 GHz, IF bandwidth = 10 Hz 112 dB 115 dB
7.5 GHz to 8.5 GHz, IF bandwidth = 10 Hz 105 dB 108 dB
1 The test port dynamic range is calculated as the difference between the test port rms noise floor
and the source maximum output power. The effective dynamic range must take measurement
uncertainty and interfering signals into account.
2 May be limited to 90 dB at particular frequencies below 350 MHz or above 4.25 GHz due to
spurious receiver residuals.