Alpha Technologies AMP24 HP - Manual (Page 60)

Doc. #: 0260011-J0 Rev B 58
6.2.2 View Group Status
Displays the operating parameters per group – AC Input, AC Output, and DC Input – that are set in
Inverters > Group Mapping .
6.2.3 Group Mapping
Ensure phases are configured correctly in the Set Output menu before mapping inverters into groups
and turning them on.
All inverters must be turned OFF to enable the AC Output Groups radio buttons.
Changing the radio style buttons (rows) will take time to apply changes; for example, approximately
two seconds for one inverter and up to ten seconds for the maximum number of inverters (32).
Figure 39 — Group Mapping window (shown for a two phase system)
Power Buttons –
Use with caution.
Shown turned off (black) to
configure inverters for AC
Output Groups,
Figure 40 — Group Status window