Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Operators Guide Rev. D - Manual (Page 88)

5 Page 5 - 14 Tank Sentinel Operator’s Guide
TS-TP2
Therm al
Printer
2" paper roll
Printer
Bezel
Serrated paper cutter
- paper output s lot
Paper
Feed Button
Routine Maintenance
• External Cleaning
Use a soft cloth, that’s moistened in a solution of mild detergent, to clean the outer
surfaces of the console.
• Replacing the Printer Paper Roll
Replace the paper roll when colored stripes
appear at the outer edges of the paper, or
when a PAPER OUT warning is flashed at
the console display...
Use INCON part number TS-TP2
— 2 inch roll of thermal printer paper
1) Install the roll as shown to the right
2) Press the paper feed button to advance the
paper through the printer mechanism
3) Feed the paper through the output slot when
closing the printer bezel and keep a slight
tension on the paper while lowering the printer
bezel to its normal position. Make sure that
the paper is not pinched between the bezel (cover) and the enclosure.
If you are installing a new roll after a PAPER OUT message is displayed, the unit will
print any reports that have been stored in memory. It will attempt to do this
immediately after paper is fed through the printer.
• Lubricate Printer:
Apply a dab of lubricant using a cotton swab to the printer shaft at the front of the
printer where the head moves across left and right — every year.
Routine Maintainance continued on the next page ...
NOTE
☞