Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Operators Guide Rev. D - Manual (Page 38)

Tank Sentinel Reports Page 3 - 3 3
Example – Automatic Alarm Reports
Alarm Reports printout automatically when they happen (the default setup enables
automatic printing for ALARMS, LEAKS, SCALD, LINES, or Generator runs)
Typical Information Shown On Reports
REPORT HEADER is printed first and shows the site
location data... site name, address, and number
REPORT DATE & TIME when the report was printed
REPORT NAME is shown next and identifies the type
of report that it is
ALARM DATE & TIME is also shown in the body of the
report for each alarm
REPORT BODY follows the report name and shows the
unique data for that type of report. For example,
delivery data is shown on Delivery Reports, and tank
setup data is shown on Tank Setup Reports.
At left, several alarms occurred at the same time. An
automatic alarm report printed several hours later after
a new roll of printer paper was installed.
Note that the print date and alarm dates are different
and that a PRINTER OUT OF PAPER alarm message
is included, which is WHY the alarms did not print out
immediately.
The following pages show typical reports and menu
selection keys to push to access these reports.
&