Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Operators Guide Rev. D - Manual (Page 12)

1 Page 1 - 2 Tank Sentinel Operator’s Guide
M ODEL : TS-1001
S/N: 121795
120 VAC, 50 / 60 Hz
A MPS M AX : 1
INTELLIGENT CONTROLS, INC. SACO, ME 04072 USA
AUTOMATIC
TANK GAUGE
&
LEAK
DETECTION
SYSTEM
MADE IN USA
Tank Sentinel ®
PN 240-1187
Figure 1 - 1. Console Component Identification – TS-1001 shown typical
Console Component Location – see Figure 1-1 above
➀
Display
The light-green backlit display consists of two rows that are 40 characters long.
Run Mode Display
The Tank Sentinel console shows up to four status-display columns in the normal run
mode. The heading names of these are: System, Tank, Sensor, and Line.
Display Normal Indications
OKAY is shown under each status-display column.
Display WARNING Indications ( also see Status Row
➂
)
WARNING is shown under the SYSTEM display column when a system software or
hardware failure occurs ( i.e.
FAX HARDWARE FAILURE )
Display ALARM Indications ( also see Status Row
➂
)
ALARM is shown under a TANK , SENSOR, or LINE display column(s) when alarms
occur ( i.e. HIGH LIMIT , HIGH BRINE, 0.2 GPH LINE LEAK )
Door hinge
(left side)
TS -1001 TANK SENTINEL ®
See Tank and Line
Display Notes
a & b (next page)
SYSTEM TANK SENSOR LINE
OKAY OKAY OKAY OKAY
M1 M2 M3 M4
LEFT RIGHT