Elmo Rietschle 2FC4...-1CB - Manual (Page 56)

7 Parameters
610.00260.40.000 · 05.2014 56 / 74 © Gardner Denver Deutschland GmbH
33.050 Stator resistance Unit: Ohm
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0 Intrinsic value
(to be en-
tered!)
max: 30
Def: Type-
specific
Here, the stator resistance can be optimised if the automatically
determined value (on the motor identification) is not sufficient.
33.105 Leakage inductance Unit: H
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0 Intrinsic value
(to be en-
tered!)
max: 100
Def: 0
Only for asynchronous motors.
Here, the leakage inductance can be optimised if the automati-
cally determined value (on the motor identification) is not suffi-
cient.
33.110 Motor voltage Unit: V
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0 Intrinsic value
(to be en-
tered!)
max: 680
Def: Type-
specific
Only for asynchronous motors.
Hereby, the rated motor voltage U
M,N
is set for either star or
delta connection.
33.111 Motor-cos phi Unit: 1
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0,5 Intrinsic value
(to be en-
tered!)
max: 1
Def: Type-
specific
Only for asynchronous motors.
Here, the power factor cosphi from the type plate data of the
motor should be entered.
33.200 Stator inductance Unit: H
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0 Intrinsic value
(to be en-
tered!)
max: 100
Def: 0
Only for synchronous motors.
Here, the stator inductance can be optimised if the automati-
cally determined value (on the motor identification) is not suffi-
cient.
33.201 Rated flow rate Unit: mVs
Relationship to
parameter: Parameter HB:
S. xy
Transfer
status:
1
min: 0 Intrinsic value
(to be en-
tered!)
max: 5000
Def: 0
Only for synchronous motors.
Here, the rated flow rate can be optimised if the automatically
determined value (on the motor identification) is not sufficient.