Extron Electronics System 5 IP Series User Guide - Manual (Page 97)

6-3 System 5 IP Switchers • Special Applications
Using IRCM control modules for DVD-VCR control
The output of a combination DVD-VCR player can be connected to a single input of
the System 5 IP, and you can install and configure Extron control modules such as
the IRCM-DVD or IRCM-DVD+, and an IRCM-VCR to control the separate sources
within the combination device.
PC DOC
CAM VCR PIC MUTE ON OFF MENU NEXT AUTO IMAGE DVD LAPTOP
2 3 4 5/ PC
DISPLAY
1
INPUT SELECTION
CONFIG IR
100-240V 1.3A
50-60Hz
Tx Rx G G S G S G S Ps +V
R
Y/C
G Y B V H VID
Y/C
VID
C Y
R/VID G/Y B/C
H V C VID V H R/VID G/Y B/C
INPUT 1
INPUT 3 INPUT 4
INPUT 2
RS-232
PROJ CONT
AU
D IO
IR/SERIAL
L 1 R L 2 R OUTPUT
A
L
B C
OUTPUT
DVD-VCR Player
IRCM-VCR IRCM-DVD
System 5 IP
DVD CONTROL
REW PLAY NEXT PAUSE STOP
Tx VCR CONTROL
REW PLAY FWD PAUSE STOP
Tx
Using an IRCM-DV+ control module for DVD-VCR control
If the combination DVD-VCR player has only one available output port and neither
a distribution amplifier nor a pair of control modules [(IRCM-DVD or
IRCM-DVD+) and IRCM-VCR] is available for use, you can create a special
switcher configuration to allow control via the System 5 IP or SCP front panel and
an optional IRCM-DV+.
100-240V 1.3A
50-60Hz
Tx Rx G G S G S G S Ps +V
R
Y/C
G Y B V H VID
Y/C
VID
C Y
R/VID G/Y B/C
H V C VID V H R/VID G/Y B/C
INPUT 1
INPUT 3 INPUT 4
INPUT 2
RS-232
PROJ CONT
AU
D IO
IR/SERIAL
L 1 R L 2 R OUTPUT
A
L
B C
OUTPUT
DVD-VCR Player
IRCM-DV+
System 5 IP
PC DOC
CAM VCR PIC
MUTE
AUTO
IMAGE ON OFF MENU NEXT DVD LAPTOP
2 3 4 5/ PC
DISPLAY
1
INPUT SELECTION
CONFIG
IR
DVD & VCR CONTROL
PLAY NEXT/FWD PAUSE STOP
TUNER
Tx
PREV/REW
ENTER
TITLE MENU
TV/VCR
DVD VCR
An IRCM-DV+ normally must be associated with two different inputs, one for the
DVD half, one for the VCR half of the IRCM-DV+. In order to use an IRCM-DV+ in
this installation, both halves must be associated with the same input.
In this example (shown above and described in the following procedure), the
DVD/VCR player’s output is connected to switcher input 3. Room/function
button 2 will be configured to associate both the DVD and VCR halves of the
IRCM-DV+ with input 3. It will also be configured to select between the DVD and
VCR halves of the IRCM-DV+.
Detailed instructions on basic configuration via Global Configurator software
are available in the System 5 IP Setup Guide.
The numbers in the sample screen shown below correspond to the procedure’s
step numbers.