Mounting the system 5 ip, Rack mounting, Rack mounting -3 – Extron Electronics System 5 IP Series User Guide User Manual
Page 13: Preliminar y, Caution, Pc video, Cl ip no rm al, Audio adjust si gn al, Co nf ig ir, Rack mounting the system 5 ip switcher
2-3
System 5 IP Switchers • Installation: Labeling, Mounting, Cabling
PRELIMINAR
Y
Mounting the System 5 IP
Rack mount the switcher, if desired, using the included rack mounting kit
(part #70-077-03), which is factory installed. Otherwise, affix the four rubber feet
(included) to the corners of the bottom of the switcher for use on a tabletop.
Rack mounting
For rack mounting, do not install the rubber feet. The rack mounting brackets are
attached to the switcher at the factory. Fasten the switcher to the rack using the
supplied machine screws.
CAUTION
The System 5 IP switchers do not contain cooling fans. Make sure there
will be adequate air circulation around the unit once it is installed. To
provide adequate air circulation and prevent overheating, Extron
recommends allowing one rack unit of space (1.75"/4.5 cm) above and
below the switcher.
SY
ST
EM
5
IP
PC VIDEO
IN
PU
T 5
CL
IP
NO
RM
AL
VO
LU
ME
AUDIO
ADJUST
SI
GN
AL
DIS
PL
AY
RO
OM
C
ON
TR
OL
IN
PU
T S
EL
EC
TIO
N
SWSTEM
SWITCHER
CO
NF
IG
IR
ME
NU
NE
XT
2
3
4
5/ RGB
1
LA
PT
OP
DV
D
VC
R
DESKT
OP
PC
1
RO
OM
RE
LA
Y
3
RO
OM
RE
LA
Y
2
RO
OM
RE
LA
Y
1
DIS
PL
AY
MU
TE
DIS
PL
AY
PO
WE
R
Rack mounting the System 5 IP switcher