Extron Electronics System 5 IP Series User Guide - Manual (Page 110)

Reference Material, cont’d
System 5 IP Switchers • Reference Material A-4
PRELIMINAR
Y
Nominal level ............................... -10 dBV (316 mV) or +4 dBu (1.23 V) (configurable)
Maximum level (600 ohm) ......... >+18 dBu, balanced at 1%THD+N
Unbalanced wired outputs will have unity gain/attenuation. Balanced outputs will result in a
6 dB gain.
Audio output — power amplifier (amplifier models only)
Number/signal type ................... 1 stereo or mono (default = stereo, configurable via front panel or control
software)
Connector ...................................... (1) 4 position screw terminal
Sensitivity ..................................... -22 dBV (80 mVrms, -19.8 dBu) for max. power output (adjustable)
Power bandwidth at rated maximum power output
4 ohm output .................... 10 Hz to 20 kHz, 0.5% THD
8 ohm output .................... 20 Hz to 20 kHz, 0.8% THD
Drive/full power out .................. 40 watts; 20 watts (rms) per channel, 4 or 8 ohm load
Protection ...................................... Input limiting, thermal, short circuit
Control/remote — switcher
Serial control port ........................ 2 RS-232: 1 rear panel 9-pin female D connector, 1 front panel 2.5 mm stereo
mini jack
Baud rate and protocol ............... 38400, 8-bit, 1 stop bit, no parity
Serial control pin configurations 2 = TX, 3 = RX, 5 = GND (9-pin D)
tip = TX, ring = RX, sleeve = GND (mini stereo jack)
Ethernet control port ................... 1 RJ-45 female
Ethernet data rate ........................ 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ......................... ARP, DHCP, ICMP (ping), TCP/IP, Telnet, HTTP, SMTP
Ethernet default settings ............ Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0,
Default gateway = 0.0.0.0
DHCP = off
Web server .................................... Up to 200 simultaneous sessions
7.25 MB nonvolatile user memory
Extron remote key pad (SCP) control
(1) 3.5 mm 5-pole captive screw connector (shared with control module and
IR Link port)
IR remote control ......................... IR 402 (optional)
Front panel: 30' maximum, 40 degrees off axis
Rear panel: 38 kHz, hardwired, modulated
Program control ........................... Extron’s configuration program for Windows ®
Extron’s Simple Instruction Set (SIS ™ )
Microsoft ® Internet Explorer, Telnet
Control — relay
Number/type ............................... 6 momentary or latching (configurable via software)
Connectors .................................... (3) 3.5 mm captive screw connectors, 3 pole
Connector configuration ............ Groups A, B, C; each with 1 common and 2 normally open relays (default)
Contact rating ............................... 24 V, 1A
Control — projector
Projector control port; RS-232 .... (1) 3.5 mm captive screw connector, 3-pole