Extron Electronics System 5 IP Series User Guide - Manual (Page 86)

SIS ™ Programming and Control, cont’d
System 5 IP • SIS ™ Programming and Control 5-30
PRELIMINAR
Y
Command/r
esponse table for SIS commands (continued)
Command
ASCII
(T
elnet)
URL Encoded (W
eb)
Response
Additional description
(host to switcher)
(host to switcher)
(switcher to host)
Set button lamps to blink slowly
24
Esc
1*
X212
LX
W1%2A
X212
LX
|
Lbk*1*
X212
X212
= Status (in hexadecimal characters) of
contr
ol of lamp enabling (contr
ol of button
lights). This variable is 00000### wher
e #
repr
esents a hexadecimal character
calculated fr
om a binary bit map. See page
5-29 for details.
V
iew which button lamps ar
e set to blink slowly
Esc
1 LX
W1LX
|
X212
Set button lamps to blink quickly
24
Esc
2*
X212
LX
W2%2A
X212
LX
|
Lbk*2*
X212
V
iew which button lamps ar
e set to blink quickly
Esc
2 LX
W2LX
|
X212
The command to set a button to blink quickly takes pr
ecedence over the command to make it blink slowly
. If a button lamp is se
t to blink both quickly and slowly
, the button
blinks quickly
.
Reset (zap) commands and erase commands
Erase user
-supplied W
eb page & files
24, 28
Esc
filename
EF
W
filename
EF
|
Del •
filename
Erase curr
ent dir
ectory and its files
24, 28
Esc
/EF
W%2F EF
|
Ddl
Erase curr
ent dir
ectory & its subdir
ectories
24, 28
Esc
//EF
W%2F%2F EF
|
Ddl
Erase the flash memory
24
Esc
ZFFF
WZFFF
|
Zpf
Reset all device settings to factory default
24
Esc
ZXXX
WZXXX
|
Zpx
The ZXXX command does
not
r
eset any IP-r
elated settings or user-defined flash memory contents.
Reset all device settings
and delete files
Esc
ZY
WZY
|
Zpy
In order to pr
eserve communication with the device, the ZY command does
not
r
eset any IP-r
elated settings , the unit name, DHCP settings, or port mapping settings.
Extr
on r
ecommends performing a ZY r
eset after you upgrade the firmwar
e.
Absolute system r
eset
24
Esc
ZQQQ
WZQQQ
|
Zpq
Reset
all
settings/memories.
The ZQQQ
command r
esets everything (all settings,
adjustments, the IP
addr
ess, and subnet
mask, PINs) to the factory default values, and it erases flash memory
.The IP
addr
ess is
reset to 192.168.254.254, the subnet mask is reset to 255.255.0.0.
This command is
identical to reset mode 5
, discussed in
“Resetting the unit” in chapter two.
Event contr
ol