Extron Electronics System 5 IP Series User Guide - Manual (Page 91)

5-35 System 5 IP • SIS ™ Programming and Control
PRELIMINAR
Y
Command/response table for special function SIS commands, continued
Command ASCII Command Response X? values
(host to Syst. 5IP) (switcher to host) and additional descriptions
Miscellaneous settings
Enable switcher slaving X? *41 # Slave* X? For X? , 0 = disable (default),
1 = enable slave control of an
Extron MPS 112CS switcher.
Set FPC lamp control 24 X? * Y? *51 # Lmp X? * Y? X? is the LED state:
0 = all LEDs are off
1 = green LED is on
2 = red LED is on
3 = green & red LEDs are on
(button glows amber).
4 = green LED blinks slowly
5 = red LED blinks slowly
6 = green & red LEDs blink
amber slowly
7 = green LED blinks quickly
8 = red LED blinks quickly
9 = green & red LEDs blink
amber quickly
Y? is which projector power or
room/function button to
control:
1 = power on button
2 = power off button
3 = room/function button 1
4 = room/function button 2
5 = room/function button 3
6 = room/function button 4.
View/query button lamp control Y? *51 # X?
This command yeilds a response of 0 if a button lighting combination other than the ones listed for X? above is set by
using the LX commands (shown on page 5-30). For example, the switcher responds with a status of 0 if the input 1
button is set to blink green slowly and red quickly at the same time.
All video out (blue screen defeat) X? *52 # AllVidOut* X? This command disables/enables
sending video signals out two
of the switcher’s output ports
(composite video and RGB or
S-video and RGB) at all times.
Enable this feature for projector
models that must receive an
active signal at each of their
inputs in order to work
properly.
For
X? ,
0 = off/disable (default)
1 = on/enable.