beautypg.com

Adjusting the encoder parameters – Extron Electronics ES3610_11 User Guide User Manual

Page 57

background image

Appendix B: Understanding VN-GLIMPSE Performance

ES3610/11 User Guide

I447GB issue 6

Page 57

Adjusting the Encoder Parameters


Using the VN-GLIMPSE Setup Utility (see page 32) you can set the following parameters:

Bandwidth Limit – If you are using a large number of RGB ADPATERS or you have a
slow/busy network, you can reduce this value which sets the maximum possible flow of data
being streamed onto the network. However, remember that this could cause the refresh rate
to be reduced, especially during periods of high source activity.

Refresh Rate (frames/sec) – If you have a source which does not require a particularly high
refresh rate, but has a reasonably active content you can set the maximum possible refresh
using this value. By keeping the Bandwidth Limit high you can keep both latency and the
average bandwidth usage to a minimum.