Extron Electronics ES3610_11 User Guide - Manual (Page 17)

ES3610/11 User Guide Section 2: Installation
I447GB issue 6 Page 17
Environmental Requirements
CAUTION
The criteria on this page must be observed for all installations of the RGB
ADAPTER, whether free-standing or rack-mounted.
Orientation
The RGB ADAPTER must be operated in the horizontal position only. When used free-standing it
must be placed on a stable, flat and level surface. Ensure that the surface finish will not be affected by
the heat produced by the RGB ADAPTER when in use.
Temperature
DO NOT install or operate the RGB ADAPTER in an area where the ambient temperature exceeds
35°C (95°F) or falls below 5°C (35°F).
Remember that, as with all electronic equipment, the RGB ADAPTER and its associated PSU also
produces heat which may affect the ambient temperature.
After the RGB ADAPTER has been in use for a period of time the external casing will be very warm to
the touch. While the temperature is well within safe limits please be aware that it may be hotter than
you are expecting. Ensure that any adjacent surfaces will not be affected by the heat.
Ventilation
No special ventilation is required. However, it is recommended that free air circulation is permitted
around the unit.
Humidity & Water
DO NOT install or operate the RGB ADAPTER in an area in which the ambient relative humidity
exceeds 85% or in an area that is prone to condensation.
DO NOT install or operate the RGB ADAPTER near water or in a location which may be prone to
water seepage — the RGB ADAPTER is not waterproof.