Extron Electronics ES3610_11 User Guide - Manual (Page 34)

Section 4: VN-GLIMPSE VIEWER ES3610/11 User Guide
Page 34 I447GB issue 6
Introduction
The VN-GLIMPSE VIEWER is a small software application that is used to display VN-GLIMPSE
sources on a conventional computer or laptop.
VN-GLIMPSE sources are captured using either:
• VN-GLIMPSE SERVER (software-based capture), or
•
VN-GLIMPSE RGB ADAPTER (hardware-based capture)
Any number of VN-GLIMPSE sources can exist on a given network. VN-GLIMPSE VIEWER can
connect to only one source at a time.
Installing the Glimpse Viewer
Minimum Computer Requirements
The VN-GLIMPSE VIEWER must be installed on a computer that meets or exceeds the following
minimum specification:
Minimum Recommended
Operating System Windows NT4 (SP6) Windows 2000, XP
Processor Any processor with MMX
instruction set Pentium 3 or higher
Memory (RAM) 64MB 128MB
Hard Disk Free Space 1MB >1MB
Graphics 1024x768, 65K colors (16-bit) 1024x768, 16.7M colors (32-bit)
Network Card Ethernet 10BASE-T Ethernet 100BASE-T
Installation Procedure
Insert the Software Disc into a CD-ROM drive on the computer. After a few seconds the disc
browser should start automatically.
HINT: If the disc browser does not start for any reason, start it manually by running the setup.exe
file located on the root of the disc.
Click on the Install VN-GLIMPSE VIEWER option then follow the on-screen instructions.