Installing the setup utility, Minimum computer specification, Installation procedure – Extron Electronics ES3610_11 User Guide User Manual
Page 29
ES3610/11 User Guide
Section 3: VN-GLIMPSE Setup Utility
I447GB issue 6
Page 29
Installing the Setup Utility
Minimum Computer Specification
The VN-GLIMPSE Setup Utility must be installed on a computer that meets or exceeds
the following minimum specification:
Minimum
Recommended
Operating System
Windows NT4 (SP6)
Windows 2000, XP
Processor
Any processor with MMX
instruction set
Pentium 3 or higher
Memory (RAM)
64MB
128MB
Hard Disk Free Space
1MB
>1MB
Graphics
1024x768, 65K colors (16-bit)
1024x768, 16.7M colors (32-bit)
Network Card
Ethernet 10BASE-T
Ethernet 100BASE-T
Installation Procedure
Insert the Software Disc into a CD-ROM drive on the computer. After a few seconds the disc
browser should start automatically.
HINT: If the disc browser does not start for any reason, start it manually by running the setup.exe
file located on the root of the disc.
Click on the Install VN-GLIMPSE Setup Utility option then follow the on-screen instructions.
- AVTrac Corner Cut Solution (2 pages)
- AVTrac Demonstration Kit (2 pages)
- AVTRac End Ramp and Cable Pass-Through Kits (1 page)
- AVTrac Extension Kit (15 pages)
- 1U and 2U Rack Plate (1 page)
- Under-Desk Mounting Bracket (1 page)
- AAP Wiring Guide 68-1054-01 (1 page)
- AAP Wiring Guide 68-1052-01 (1 page)
- AAP Wiring Guide (XLR connectors) (1 page)
- AAP 314 (1 page)
- AAP 301 (1 page)
- AAP Wiring Guide 68-1055-01 (1 page)
- AAP Wiring Guide 68-1058-01 (1 page)
- AAP Wiring Guide 68-1059-01 (1 page)
- AAP-MAAP Rev. A (1 page)
- AAP-MAAP Rev. D (1 page)
- MD Floor Box AAP Bracket Kit AAP 100 MD (1 page)
- AC 100 Power Module Series (1 page)
- AAP 103 Extron Ackerman AKM UK Faceplate Kit (1 page)
- ACMP 100 (2 pages)
- Active Audio AAP (1 page)
- AKM UK Series (4 pages)
- Audio AAP Wiring Guide (1 page)
- Audio Connector Rev. A (2 pages)
- Audio Connector Rev. G (1 page)
- AVTrac Extra Channel Kit (2 pages)
- AVTrac Raceway Transition (2 pages)
- AVTrac Retrofit Transition Adapter (2 pages)
- AVTrac Trim Ring-Rough-in Adapter (2 pages)
- AVTrac Above Floor (1 page)
- BB 1 (2 pages)
- BB 1000M (2 pages)
- BB 700M (2 pages)
- BB 710M (2 pages)
- Blank Rack Panel (1 page)
- BNC to 15-Pin HD (1 page)
- BNC-5 RC Termination (1 page)
- Cable Cubby 1200 (6 pages)
- Cable Cubby 200 (18 pages)
- Cable Cubby 300C (27 pages)
- Cable Cubby 500 (6 pages)
- Flexible Conduit Kit (2 pages)
- Cable Cubby Lid and Trim Ring Replacement Kit (for 300C, 300S, 600, 800) (1 page)
- Cable Cubby Setup Guide (4 pages)
- Cable Cubby Single Space AAP Bracket Kit (1 page)