Extron Electronics MVX VGA A User Guide - Manual (Page 34)

3-11 MVX VGA A Matrix Switchers • Operation
PRELIMINAR
Y
Example 2: Adding a tie to a set of video and audio ties
In the following example, a new video tie is added to the current configuration.
The steps show the front panel indications that result from your action.
N This example assumes that you have performed example 1.
1 . Press and release the Esc button (figure 3-9).
ENTER PRESET VIEW ESC
CONTROL
Press the Esc button to clear all selections.
The LED blinks once. = LED blinks once. 1
1
Figure 3-9 — Clear all selections
2 . To select video only for the tie, if necessary, press and release the RGBHV
button and/or Audio button (figure 3-10).
RGBHV AUDIO
I/O
Press the RGBHV button to toggle on and off.
The LED lights when selected.
Press the Audio button to toggle on and off.
The LED is
unlit when deselected.
Figure 3-10 — Select RGBHV only
3 . Press and release the Input 5 button (figure 3-11).
2 3 4 5 6
INPUTS
7
1 2 3 4 5
OUTPUTS
6 7 8
The Output 3, Output 4, and Output 8 LEDs light to indicate
the RGBHV ties created in example 1.
Press and release the Input 5 button.
The LED lights.
Figure 3-11 — Select an input
4 . Press and release the Output 1 button (figure 3-12).
1 2 3 4 5
OUTPUTS
6
ENTER PRESE
Press and release the Output 1 button.
The LED blinks to indicate that the selected
RGBHV input will be tied to this output.
The Enter LED blinks to indicate
the need to confirm the change.
Figure 3-12 — Select the output