Extron Electronics MVX VGA A User Guide - Manual (Page 14)

1-5 MVX VGA A Matrix Switchers • Introduction
PRELIMINAR
Y
Upgradeable firmware — The firmware that controls all switcher operation can be
upgraded in the field via either serial port, without taking the switcher out of
service. Firmware upgrades are available for download on the Extron Web
site, www.extron.com, and can be installed using the Windows-based control
program.
Labeling — The Extron button label software ships with every Extron matrix
switcher. You can create labels to place above the front panel input buttons
and below the output buttons, with names, alphanumeric characters, or color
bitmaps for easy and intuitive input and output selection. Alternatively,
labels can be made with any Brother ® P-Touch ™ or comparable labeler.
Global memory presets — 32 global memory presets are a time-saving feature that
lets you set up and store input/output configurations in advance. You can
then recall those configurations, when needed, with a few simple steps on the
front panel. For the MVX 128 A, which has fewer input and output buttons,
20 global memory presets are available from the front panel; the remaining
presets are available via serial port control.
Rack mounting — Rack mountable in any conventional 19" wide rack.
Three front panel security lockout modes ( Executive modes) — If a matrix
switcher is installed in an open area, where operation by unauthorized
personnel may be a problem, either of two security lockout modes can be
implemented (the third mode is unlocked). When a front panel locked mode
is enabled, a special button combination or SIS command is required to
unlock the front panel controller and make the front panel fully operational.
Power — The matrix switcher’s 100 VAC to 240 VAC, autoswitchable, internal
power supply provides worldwide power compatibility.