Extron Electronics MVX VGA A User Guide - Manual (Page 22)

2-7 MVX VGA A Matrix Switchers • Installation
PRELIMINAR
Y
Reset button
g
Reset button — The Reset button initiates two levels of reset to the
matrix switcher. For the two different reset levels, press and hold
the button while the switcher is running or while you power up the
switcher.
See “Rear Panel Operations” in chapter 3, “Operation”, for details.
• Rear panel (mode 5) system reset — Press and hold the Reset button
until the Reset LED blinks three times (approximately 9 seconds), then
release the button and press it again. This reset clears all ties and presets
and resets all audio gains to 0 dB.
• Hard reset — Press and hold the Reset button while powering up the
switcher to restore the switcher to the default factory conditions.
N Hard reset does not clear the current configuration.
Power connection
h
AC power connector — Plug a standard IEC power cord into this connector to
connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
RESET