Extron Electronics VN-Matrix 300 User Guide - Manual (Page 69)

VN-Matrix 300 • Alarms and SNMP 63
Alarm Type Description — Encoder
Alarm Type Description Action Default Settings
Encoder Alarm
No source No source present at the input. Check input
connections; is there
an output on the loop
through connector? Critical, reporting
Bad source syncs Source is present, unrecognized
due to bad sync measurement. Critical, reporting
No SDI source lock Source is present, unable to lock Critical, reporting
Unsupported SDI Mode Source is present, mode not
supported
Critical, reporting
Unsupported Mode Not applicable to VN-Matrix 300 N/A
Bad Source Not applicable to VN-Matrix 300 N/A
Analogue Phasing error Not applicable to VN-Matrix 300 N/A
Hardware encoding
error The hardware is unable to
encode the input signal. Critical, reporting
Unsupported audio
source Not applicable to VN-Matrix 300 N/A
Data rate overload The compressed data rate is too
high. Increase the
compression or
reduce the required
bit rate Critical, reporting
Network overload The network is dropping too
many packets. Warning,
reporting