Extron Electronics VN-Matrix 300 User Guide - Manual (Page 57)

VN-Matrix 300 • System Configuration 51
Client Mode
From the Devicepage, Peripherals tab of each device in the client group, configure the client
devices.
1. On the Device page, click on the device you want to configure as a client.
2. Select the Peripherals tab.
3. Set the mode
a
to client.
This reveals the destination listbox.
4. In the destination
b
listbox, select passthrough for the appropriate server.
5. Change the other settings
c
(baud rate, data bits, stop bits, parity, and handshake) as
required.
6. Click Save All tab.
Figure 38. Serial Pass-through Group — Client Mode