Extron Electronics VN-Matrix 300 User Guide - Manual (Page 39)

VN-Matrix 300 • System Configuration 33
Encoder Streams Panel
The Streams panel of the Configure page for an encoder provides information on any
active streams that are configured on the encoder.
z Stream definition — Provides information on any active streams from the Encoder.
z
Streams are provisioned at the display (decoder) device.
z
Once a stream has been provisioned the details will appear in the listing.
RTP UNICAST Streams
When the multicast option is not selected, a decoder may connect using either:
z TCP/IP connection — Used for guaranteed delivery on point to point (single connection)
systems.
z RTP UNICAST connection — Streams are sent as RTP Unicast.
NOTE: In this mode, up to 4 simultaneous streams are supported. This is
dependant on the total aggregated bit rate – which must not exceed
270 Mbs.
Configuring a Multicast Connection
When the Multicast enable option (see figure 19 ) is selected, the user may configure a
multicast connection.
z The user is prompted to enter a Multicast group address in the range 224.nnn.nnn.nnn
to 239.nnn.nnn.nnn.
z Streams are sent as RTP Multicast.
z Note that the VN-Matrix 300 supports IGMP V2 for multicast working.
New export stream
This function is not supported.