Table of contents, cont’d, Testing the globalviewer pages – Extron Electronics MLC 104 Plus Series Setup Guide User Manual
Page 6
ii
MLC 104 Plus Series • Table of Contents
Table of Contents, cont’d
68-1289-01 Rev. D
11 08
All trademarks mentioned in this manual are the properties of their respective owners.
Step nine: assign serial device drivers ................................ 3-14
Step ten: assign IR drivers ................................................... 3-15
Step eleven: configure the front panel .............................. 3-16
Button caption .....................................................................3-16
Button tool tip ......................................................................3-16
Button repeat rate ................................................................3-17
Button modes .......................................................................3-18
Switcher input ......................................................................3-19
Button operations ................................................................3-20
Clear, reset, and auto fill captions .......................................3-24
Step twelve: configure associated control modules ......... 3-25
Step thirteen: create a shutdown schedule ....................... 3-27
Step fourteen: create a lamp hour notification (IP models
only) ...................................................................................... 3-29
Step fifteen: create a disconnect notification
(IP models only).................................................................... 3-31
Step sixteen: build the Global Configurator file ............... 3-33
Step seventeen: upload the Global Configurator file ....... 3-34
Step eighteen: launch GlobalViewer (IP models only) ...... 3-35