Extron Electronics MLC 104 Plus Series Setup Guide User Manual
Page 5
i
MLC 104 Plus Series • Table of Contents
i
Table of Contents
.................................................... 1-1
.................................................................... 1-2
The MLC 104 Plus Series MediaLink
Differences between models ................................................ 1-2
.................................................... 1-4
Global Configurator Online Training
.................................. 1-6
............................................ 2-1
................................................................................... 2-2
......................................................................... 2-3
............................................... 2-4
..................................................................... 2-5
LAN Connection (IP Models Only)
........................................ 2-6
Front Panel Host Configuration Port
................................... 2-7
................................................................... 2-8
Display connection ................................................................. 2-8
Infrared (IR) connection ......................................................... 2-8
Digital I/O connection ............................................................ 2-8
Comm Link connection .......................................................... 2-9
MLS connection ...................................................................... 2-9
Chapter Three • Software Setup
......................................... 3-1
Creating a Global Configurator Project File
Step one: download device drivers ...................................... 3-2
Step two: create a new project ............................................. 3-4
For IP models ..........................................................................3-4
For an MLC 104 Plus (non-IP model)......................................3-5
Step three: add a device and set up its connection ............ 3-6
For IP models ..........................................................................3-6
For an MLC 104 Plus (non-IP model)......................................3-8
Step four: define the location of the new device
(IP models only)...................................................................... 3-9
Step five: save the new Global Configurator file .............. 3-10
.................................................... 3-11
Step six: configure e-mail server (IP models only) ............ 3-11
Step seven: configure e-mail messages (IP models only) . 3-12
Step eight: configure contacts (IP models only) ................ 3-13
Table of Contents