System requirements, Installing global configurator – Extron Electronics MLC 104 Plus Series Setup Guide User Manual
Page 11
MLC 104 Plus Series • Introduction
1-5
Using GC you can configure a single room controller, or create
a web-based remote monitoring system for hundreds of A/V
devices in multiple locations.
You may configure an MLC using GC without having the device
physically connected to the A/V network.
N
For MLC 104 IP Plus models, use Global Configurator
version 2.2 or later. For MLC 104 Plus models, use
version 2.5 or later. Update all PCs and devices running
earlier versions of GC.
System Requirements
The minimum system requirements for the PC on which you
install Global Configurator include:
• Intel
®
Pentium
®
III 1 GHz processor
• Microsoft
®
Windows
®
NT SP4, Windows 2000 SP2, or
Windows XP SP2
• Microsoft Internet Explorer
®
6.0 with ActiveX
®
enabled
N
If ActiveX is not enabled, you may get a prompt from the
browser, or you will see the “Please wait while the files are
loading...” message in the GlobalViewer control page.
• Microsoft Windows Script 5.6
• 512 MB of RAM
• 50 MB of available hard disk space
• A network connection with a minimum data transfer rate of
10 Mbps; however, 100 Mbps is recommended.
Installing Global Configurator
Global Configurator software is available free from Extron.
To download and install Global Configurator on your PC:
1
.
Go to www.extron.com
2
.
Click the Download tab.
3
.
Click the IP Link
®
Software
icon.
4
.
Click the Global Configurator icon.
5
.
Click the Download Now button.
6
.
Complete the personal information form.
7
.
Click the Download GCSWxxxxx.exe button.
8
.
Follow the remaining system prompts.