Extron Electronics ISM 482 - Manual (Page 20)

ISM 482 Integrated Scaling Matrix Switcher • Operation 14
Auto imaging an input
The auto imaging feature automatically sizes and centers the selected input to fill the
screen. Initiate the auto imaging feature for a specific input by pressing and
holding
the appropriate input button until the LCD displays the message Auto Image Input
#n, releasing the input button, and then pressing and releasing the input button again.
The LCD displays
AutoSizing and Centering Please Wait... until the operation is
complete.
Alternatively, using the menu system, you can set this feature to apply the Auto Image
adjustments to every input as it is selected (see
Auto Imaging and Auto Memories
submenu on page 22).
Black/Mute Button and LEDs
e
Black/Mute button and LEDs — The Black/Mute button switches the selected
output(s) to a black screen and/or muted audio. The black screen and/or mute audio is
deselected when a new input is selected.
Picture Adjustment Buttons
f
The picture adjustment buttons select individual image adjustments that are adjusted
using the Adjust and Adjust knobs ( i ). The LEDs above these buttons light when
the button is pressed (see Picture Adjustments on page 25).
Color/Tint control button — The Color/Tint button selects the display color and tint
adjustments. The color adjustment range is from 0 to 127. The tint adjustment range is
from 0 to 255.
NOTE: The Color/Tint control affects only composite video and S-video inputs.
Brightness/Contrast control button — The Brightness/Contrast button selects the
display brightness and contrast adjustments. The adjustment range for both brightness
and contrast is from 0 to 63.
Size control button — The Size button selects the display size adjustment. The
adjustment range depends on the output resolution selected.
Center control button — The Center button selects the display centering adjustment.
The adjustment range depends on the output resolution selected.
Filter control (Detail) button — The Detail button selects the display image detail
(sharpness) adjustment. There are separate horizontal and vertical filters for RGB
and component video. There is a single filter for S-video and composite video. The
sharpness adjustment compensates for long cable runs.
• For RGB and component video, the Adjust knob controls the horizontal filter and
the Adjust knob controls the vertical filter. The adjustment range for the horizontal
filter is from 0 to 3. The adjustment range for the vertical filter is from 0 to 7.
• For S-video and composite video, either Adjust knob controls the filter setting. The
range of the adjustment is from 0 to 7.