Extron Electronics FOX 500 DVI Tx User Guide - Manual (Page 43)

FOX 500 Tx/Rx • Reference Information
Reference Information, cont’d
FOX 500 Tx/Rx • Reference Information A-8 A-9
Transmission power
Singlemode ......................... -5 dBm, typical
Multimode .......................... -5 dBm, typical
Maximum receiver sensitivity
Singlemode ......................... -18 dBm, typical
Multimode .......................... -12 dBm, typical
Optical loss budget
Singlemode ......................... 13 dB, maximum
Multimode .......................... 7 dB, maximum
Video
Resolution range ........................... Single link DVI and HDMI digital
video signals are supported, including
640x480 @ 60 Hz through 1600x1200 @
60 Hz, and also HDTV signals at 480p,
720p, 1080i, and 1080p.
Higher resolutions up to 1920x1200 @ 60
Hz, undersampled
N The FOX 500 DVI Series can be used to distribute HDMI signals
if you use a DVI-to-HDMI adapter. However, when using HDMI
signals, the FOX units do not transmit audio and CEC signals.
Formats ........................................... RGB and YCbCr digital video
Standards ........................................ DVI 1.0, HDMI 1.2
Video input and loop-through — transmitter
(FOX 500 DVI Tx)
Number/signal type ..................... 1 DVI-D (or HDMI*) input
1 DVI-D (or HDMI*) loop-through
Connectors ..................................... 1 female DVI-I for input
1 female DVI-I for loop-through
Nominal level ................................ 0.8 Vp-p
Impedance ...................................... 100 ohms
N *Appropriate DVI-D to HDMI cables or adapters are required
for HDMI signal input/output.
Video output — receiver (FOX 500 DVI Rx)
Number/signal type ..................... 1 DVI-D (or HDMI*)
Connectors ..................................... 1 female DVI-I
Nominal level ................................ 0.8 Vp-p
Impedance ...................................... 75 ohms
Video delay .................................... 1-2 frames
Audio
Gain
Range .................................. Adjustable, -18 dB to +10 dB
Default
Captive screw connector
Unbalanced output: -6 dB;
balanced output: 0 dB
Mini stereo jack .......... Unbalanced output: 0 dB
Frequency response ...................... 20 Hz to 20 kHz, ±0.5 dB
THD + Noise .................................. 0.10% @ 1 kHz at nominal level
S/N .................................................. >80 dB at maximum output (unweighted)
CMRR .............................................. 65 dB @ 20 Hz to 20 kHz
Audio bits per sample .................. 18 bits per channel, 2 channels (L, R)
Sampling rate ................................. 48 kHz
Audio input — transmitter (FOX 500 DVI Tx)
Number/signal type ..................... 2 inputs (mixed): 1 balanced stereo;
1 unbalanced stereo or 2 unbalanced mono
Connectors ..................................... (1) 3.5 mm captive screw connector, 5 pole
(1) 3.5 mm mini stereo jack
Impedance ...................................... 18k ohms unbalanced, 20k ohms balanced,
DC coupled
Nominal level ................................ +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level .............................. +17 dBV, (unbalanced) at 1% THD+N
N 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — receiver (FOX 500 DVI Rx)
Number/signal type ..................... 2 buffered outputs: 1 balanced stereo; 1
unbalanced stereo or 2 unbalanced mono
Connectors ..................................... (1) 3.5 mm captive screw connector, 5 pole
(1) 3.5 mm mini stereo jack
Impedance ...................................... 50 ohms unbalanced, 100 ohms balanced
Nominal level ................................ +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level (Hi-Z) ................. >+19 dBu, unbalanced at 1% THD+N
Maximum level (600 ohm) ........... >+15 dBm, unbalanced at 1% THD+N
Audio delay ................................... 1.5 frames
Control/remote
Serial control ports on each unit (transmitter and receiver)
Control ................................ 1 RS-232, 3.5 mm captive screw connector,
5 pole (3 pins are used) (rear panel)
1 RS-232, 2.5 mm mini stereo jack (front panel)