Extron Electronics FOX 500 DVI Tx User Guide - Manual (Page 32)

FOX 500 Tx/Rx • Remote Contr
ol
Remote Contr
ol, cont’d
4-14
FOX 500 Tx/Rx • Remote Contr
ol
4-15
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Disable and enable return link
N This function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the receiver is connected to any of
outputs 2 through 6 on the DA.
Disable return link 66*0*0# Rle*0*0 ] Disable link #2.
Enable return link 66*0*1# Rle*0*1 ] Enable link #2 (default setting).
Show return link status 66*0# 0* X2@]
Information requests
Information request I 1Link X1^ •2Link X1^ •RGB X1^ •Aud X1^ • X1& • X1*]
The unit responds with the current status (signal
detected) of optical link 1, optical link 2, the video input,
the audio input, the fiber optic mode (singlemode or
multi mode), and the device type (Tx or Rx).
N The receiver monitors the fiber 1 cable. If the PC is connected to the transmitter and fiber cable 2 is not installed, for the information request
(I) and Status commands (S) below, the transmitter reports 1Link0 regardless of the status of the fiber 1 cable.
Command/response table for SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Information requests (Continued)
Show firmware version Q X1%]
Example: Q 1.23 ] The factory-installed FOX 500 controller firmware version
is 1.23 (sample value only).
Request connected unit's
part number N 60-nnn-nn ] See appendix A for part numbers.
Show link 1 status 1S X1^] 0 = light link not received at receiver, 1 = light received.
Show link 2 status 2S X1^] 0 = light link not received at transmitter, 1 = light received.
Show input video status 3S X1^] 0 = video is not input to the transmitter, 1 = video is input.
Show input audio status 4S X1^] 0 = audio is not input to the transmitter, 1 = audio is input.
Show temperature 20S X2#] View internal temperature in degrees Fahrenheit and
Celsius.
Resets
Reset audio E ZA } Zpa ] Reset all audio settings to default levels (0 dB gain and
consumer [-10 dB] level).
Reset presets E ZG } Zpg ] Reset (erase) all memory presets.
System reset E ZXXX } Zpx ] Reset all settings to the factory defaults.
Command/response table for SIS commands (continued)
N
X2@ = Link 2 enable 0 = disable 1 = enable (default)
X1^
= Link/input status 0 = link or input not sensed 1 = link or input sensed
X1&
= Mode SM = singlemode MM = multimode
X1*
= Transmitter or receiver Tx = transmitter Rx = receiver
N
X1%
= Firmware version v .vv
X1^
= Link/input status 0 = link or input not detected 1 = link or input detected
X2# = Internal temperature (Fahrenheit and Celsius) nnn F•nnC