Extron Electronics FOX 500 DVI Tx User Guide - Manual (Page 22)

FOX 500 Tx/Rx • Operation
Operation, cont’d
3-6 FOX 500 Tx/Rx • Operation 3-7
Horizontal Start submenu
The Horizontal Start submenu defines the horizontal position
of the first active pixel in the active area or the receiver's output.
Rotate either Adjust knob while in this submenu to set the start
variable.
Total Pixel and Pixel Phase submenu
The Total Pixel and Pixel Phase submenu displays and lets
you set the total number of pixels and the pixel phase. Rotate
the Adjust [ knob to adjust the total pixels within 255 of the
default value (the input's horizontal resolution). Rotate the
Adjust { knob to select the pixel phase from 0 to 31. The default
is 16.
Output Configuration menu
Figure 3-4 is a flowchart that shows an overview of the Output
Configuration menu, its submenus, and the available settings.
ADVANCED
CONFIG
Menu
Menu
30 sec.
• RGBHV
• RGsB
Menu
Next
Menu
Menu
Menu
OUTPUT
CONFIG
30 sec. 30 sec.
Next
Menu
SYNC
<
FLW
>
FORCE
Next
PICTURE
CONTROL
AUDIO
CONFIG
MEMORY
PRESETS
Menu
EXIT MENU
PRESS NEXT
Menu
FOX 500
nn.nk nnHz
* This submenu is
available only when an
RGB
or DVI transmitter is
connected to a FOX 500
(RGB) receiver.
FORMAT
RGBHV
*
Figure 3-4 — Output Configuration menu flowchart
N The Format submenu is available only when either
an RGB or DVI transmitter is connected to an RGB
receiver.
Format submenu
Rotate either Adjust knob while in the Format submenu to select
the desired video output format (RGBHV or RGsB).
Sync submenu
The display or projector may require a negative sync signal.
Rotate either Adjust knob to select FLW (Follow) (the output
video sync follows the input) or Force (sync is forced negative).
Audio Configuration menu
Figure 3-5 is a flowchart that shows an overview of the Audio
Configuration menu, its submenus, and the available settings.
ADVANCED
CONFIG
Menu
Menu
30 sec.
-18.0 dB to
+10.0 dB
Menu
Next
Menu
Menu
Menu
AUDIO
CONFIG
30 sec. 30 sec.
OUTPUT LVL
<
CONS> PRO
Next
Menu
Menu
MUTE
<
OFF
>
ON
Next
Next
OUTPUT
CONFIG
PICTURE
CONTROL
MEMORY
PRESETS
Menu
EXIT MENU
PRESS NEXT
Menu
FOX 500
nn.nk nnHz
* This submenu is only
available when both
fiber cables are
installed between the
transmitter and receiver.
* GAIN
00.0 dB
Figure 3-5 — Audio Configuration menu flowchart
N The Gain submenu is available only when both fiber
cables are installed between the transmitter and receiver.
Gain submenu
Rotate either Adjust knob while in the Gain submenu to select
the input audio gain or attenuation value, from -18 dB to +10 dB
in 1.0 dB increments. The default is a 0 dB audio level.
Mute submenu
Rotate either Adjust knob while in the Mute submenu to select
or deselect the audio output mute function.