Extron Electronics FOX 500 DVI Tx User Guide - Manual (Page 24)

FOX 500 Tx/Rx • Operation
Operation, cont’d
3-10 FOX 500 Tx/Rx • Operation 3-11
N The DDC Resolution submenu is available only when
the receiver is onnected to a FOX 500 DVI receiver
AND both fiber cables are installed between the
transmitter and receiver.
Auto Memory submenu
The auto memory function automatically saves the horizontal
and vertical position, horizontal start, total pixels, and pixel
phase settings for different input resolutions. When on, auto
memory applies the settings based on the detected input
resolution.
Rotate either Adjust knob while in the Auto Memory submenu
to select (< >) either on or off for the auto image function. Press
the Next button to save the current settings.
Auto Image Trigger submenu
The auto image function adjusts the output settings for the best
image, based on the detected input resolution.
Rotate either adjust knob to trigger the auto image function.
N If no video input is connected, the submenu display reads
Auto Image N/A and no function is available from this
screen.
Pattern submenu
The receiver can output any of three test patterns that help you
adjust the display's color, focus, and grayscale. Rotate either
Adjust knob while in the Pattern submenu to select among the
Color Bars, grayscale, and alternating pixels test patterns.
N You must have a video input connected and fiber cable
Optical 1 connected between the transmitter and receiver
for the receiver to output a selected test pattern.
The test pattern will turn off if the input signal rate is
changed or disconnected or if power is removed.
The size of the test pattern depends on the size of the
active input signal. Any picture adjustments made on
the input affect the test patterns as well.
Link #2 submenu
Rotate either Adjust knob while in the Link #2 submenu to
enable or disable the Optical 2 link to the transmitter.
N This function is primarily used and recommended when
the transmitting device is a FOX 500 DA6 and the
receiver is connected to any of outputs 2 through 6 on
the DA.
Temperature display
The temperature display shows the internal temperature of the
unit. No adjustment is possible.
DDC Resolution submenu
N The transmitter's rear panel DDC Resol(ution) rotary
switch must be in position 1 for the variables to be
changeable via this submenu.
Rotate the Adjust [ knob while in the DDC Resolution
submenu to select the output resolution. Rotate the Adjust {
knob to select the refresh rate.
Exit menu
From the Exit menu (figure 3-8), press the Next button to return
to the default display cycle, or press the Menu button to return
to the Picture Control menu.
AUDIO
CONFIG
Menu
Menu
30 sec.
Menu
Menu
Menu
EXIT MENU
PRESS NEXT
OUTPUT
CONFIG
PICTURE
CONTROL
Menu
ADVANCED
CONFIG
Menu
Next
MEMORY
PRESETS
FOX 500
nn.nk nnHz
Figure 3-8 — Exit menu flowchart