GE Industrial Solutions Galaxy Verification - Manual (Page 79)

Galaxy Power System Verification Procedures
Issue 3 January 2008 Replacement Procedures 4 - 11
GPS2424 Replacement Procedures, continued
Installing or
Replacing a 596B3
Rectifier, continued
Step Action
5 Slowly slide new rectifier onto the shelf until it contacts the
rear connector.
6 Using the Allen wrench, turn the Allen-head bolt clockwise
to pull the rectifier into the shelf.
7 Once the rectifier has been installed, set the rectifier ID.
(Refer to product manual.)
Note: The red LED on the rectifier will blink until the
rectifier establishes communication with the controller.
After communication is established, the controller will issue
a RECT MAJ alarm until the rectifier ID is set.
8 Turn the ac service back on.
9 Turn the rectifier’s ON/STBY switch to ON.
!