Ocean Optics S1024DW Install - Manual (Page 63)

60
H1 Header Pins (Analog)
1 Analog Channel 0
2 Analog Channel 1
3 Analog Channel 2
4 Analog Channel 3
5 Analog Channel 4
6 Ground
7 Reserved
8 Analog Channel 7
9 Analog Channel 6
10 Analog Channel 5
H2 Header Pins (Digital)
F Inverted Clock 2
E Inverted Clock 1
D N/C
C A/D Trigger
B Digital In 3 (D3)
A S1
1 Ground
2 +5 VDC
3 Clock 1
4 Store Clock
5 Clock 2
6 Temperature (optional)
7 Read Enable
8 S0
9 Strobe Single flash
10 Strobe Multiple Flash
11 Integration Clock
12 Master Clock
J1 = 25-pin connector that connects the S1024DW master with the A/D board
J2 = 15-pin accessory connector
H1, H2 = header blocks that connect a master unit to one or more slave units
Continuous Strobe Rate
The continuous strobe rate is controlled by the A/D frequency input to the spectrometer and the position of
the jumper JP3. The jumper selects a divider for the input clock. To change the jumper it is necessary to
remove the S1024DW from its housing.
Jumper Position Divisor
S1024DW Flash Rate
(running @ 200 kHz)
1 Buffered input from D25 pin 20
2 2 10 195 Hz
3 2 12 48.8 Hz
4 2
14
12.2 Hz
5 2
16
3.1 Hz