Table 27 - configure serial port 1 as tcp client – B&B Electronics APXN-Q5428 - User Manual User Manual
Page 49
AirborneM2M™ Users Guide
B&B Electronics, Inc.
1/9/2014
49
Table 27 - Configure Serial Port 1 as TCP Client
Step
Description
Navigation Bar
Select Configuration
You will see a group of fields under the
banner of WLAN Parameters.
Feature Link
Select Connection Settings
The wireless interface and security must be
configured before configuring the Ethernet
settings.
You will see a page showing the
configuration options for TCP/IP and UDP
connections to the device. You may
configure Telnet, HTTP and SSH ports on
this page.
Select TCP Port
Enter the port on which the target server is
listening for TCP connections.
Select TCP Timeout
Enter the inactivity timeout in seconds, after
which the device will close the open data
tunnel on Serial Port 1.
The default 0 disables the timeout.
Select TCP Retry Time
Enter the period(in seconds)that the device
should use to retry establishing the TCP
connection to the target server.
Select Primary TCP Target Server IP Address
Enter the IP address of the primary target
server.
The address must be in the format:
XXX.XXX.XXX.XXX
Optional
Select Secondary TCP Target Server IP
Address
Enter the IP address of the secondary target
server.
The address must be in the format:
XXX.XXX.XXX.XXX
This address will be used if the initial
attempts to connect to the primary server
fail. This field is optional.
Press Commit [Button]
Saves changes to the device.
Press Reload [Button]
Reloads the Connection Settings page.
Feature Link
Select Serial Port 1 Settings
The wireless interface and security must be
configured before configuring the Ethernet
settings.
You will see a page showing the serial port
configuration. You may set the default
mode of operation for the serial interface on
this page.
Select Serial CLI Default Mode
Select Pass from the drop down menu.
Press Commit [Button]
Saves changes to the device.
Optional
Press Reload [Button]
Reloads the Serial Port 1 Settings page.
Select this if you wish to change additional
configuration options.