B&B Electronics APXN-Q5428 - User Manual - Manual (Page 103)

AirborneM2M™ Users Guide B&B Electronics, Inc.
1/9/2014 103
Laird CAF 94505 2.0 4.0 50
Nearson T131AH-2.4/4.9/5.X-S 2.0 2.0 50
Taoglas GW.71.5153 3.8 5.5 50
Taoglas PC.11.07.0100A 3.0 4.5 50
Taoglas WS.01.B.305151 4.1 4.7 50
Taoglas FXP.810.07.0100C 2.4 5.1 50
Taoglas FXP.830.07.0100C 2.6 5.0 50
The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit RF field in excess of Health Canada limits for
the general population; consult Safety Code 6, obtainable from Health Canada’s
website www.hc-sc.gc.ca.
This Device complies with Industry Canada license-exempt RSS
standard(s).Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
17.4 FCC/IC Modular Approval
This document describes the Airborne WLN FCC modular approval and the
guidelines for use as outlined in FCC Public Notice (DA-00-1407A1).
The APXx-Q5xxx is covered by the following modular grants:
Table 30 - Modular Approval Grant Numbers
Country Standard Grant
North America (US)
FCC Part 15
Sec. 15.107, 15.109, 15.207, 15.209, 15.247
Modular Approval
F4AWLNN551
Canada
RSS 210
Modular Approval
3913A-WLNN551
By providing FCC modular approval on the Airborne WLN modules, the
customers are relieved of any need to perform FCC part15 subpart C Intentional
Radiator testing and certification, except where they wish to use an antenna that
is not already certified.
B&B Electronics supports a group of pre-approved antenna; use of one of these
antennas eliminates the need to do any further subpart C testing or certification.
If an antenna is not on the list, it is a simple process to add it to the pre-approved
list without having to complete a full set of emissions testing. Please contact B&B
Electronics Technical support for details of our qualification processes.