B&B Electronics APXN-Q5428 - User Manual - Manual (Page 101)

AirborneM2M™ Users Guide B&B Electronics, Inc.
1/9/2014 101
17.0 Certification & Regulatory Approvals

IMPORTANT!
It is required that the following section be read and understood
before use of the B&B Airborne™ device is permitted.
Use of approved antenna is required for compliance to FCC and IC
regulations.
The unit complies with the following agency approvals:
Table 29 - Regulatory Approvals
Country Standard Status
North America (US & Canada) FCC Part 15
Sec. 15.107, 15.109, 15.207, 15.209,
15.247
Modular Approval
Complete
Europe CISPR 16-1 :1993
ETSI EN 300 328 Part 1 V1.2.2 (2000-07)
ETSI EN 300 328 Part 2 V1.1.1 (2000-07)
Complete
Japan ARIB STD-T71 v1.0, 14 (Dec 2000)
ARIB RCR STD-T33 (June 19, 1997)
ARIB STD-T66 v2.0 (March 28, 2002)
Pending
17.1 FCC Statement
This equipment has been tested and found to comply with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
 This device may not cause harmful interference, and
 This device must accept any interference received, including
interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.