B&B Electronics VESR4X4 - Manual - Manual (Page 41)

Section 4 - Configuring the Serial Server Vlinx VESR4x4 Serial Server
Page 41 of 70
www.bb-elec.com/
www.bb-europe.com/
3. Type the TCP port number to be used in the I want to wait for connections
on TCP port number box.
4. Select the number of connections in the
and limit the number of
connections to drop down box.
5. Select:
 and allow everyone to connect - if you want any server to connect
 and allow a specific IP address to connect - if you want to specify
up to four IP addresses to be able to connect
 and allow a specific range of IP addresses to connect - if you want
to specify a range of IP addresses that can connect
6. If you selected
 and allow a specific IP address to connect , in the area of the
window that appears, select one or more IP address boxes and type in
the desired IP address
Figure 37. IP Addresses

and allow a specific range of IP addresses to connect
, in the area of
the window that appears, select an IP address box and type in the IP
addresses that specify the desired range
Figure 38. IP Address Ranges
Setting up Advanced Network Settings
On the Advanced Network Settings window you can configure if network
connections are automatically closed due to inactivity and when serial data is
forwarded to the network.