B&B Electronics VESR4X4 - Manual - Manual (Page 38)

Section 4 - Configuring the Serial Server Vlinx VESR4x4 Serial Server
Page 38 of 70
www.bb-elec.com/
www.bb-europe.com/
 If you selected: everyone on a specific UDP port (send broadcast) ,
type the UDP port number into the This is the UDP port I want to
send data to:
box
 If you selected: only specific IP addresses (send unicast) , type the
IP addresses and port numbers into the These are the IP addresses I
want to send data to: text boxes
 If you selected:
only a range of IP addresses (send unicast range)
,
type the ranges of IP addresses and port numbers into the These are
the IP addresses I want to send data to: text boxes
4. Select the required Receive options:
a. nobody - receives from nobody
b. everyone on a specific UDP port (receive broadcast) - receives from
all UDP ports on the network (specified later)
c. only specific IP addresses (receive unicast) - receives from specific
network IP addresses (specified later)
d.
only a range of IP addresses (receive unicast range)
- receives from
all IP addresses within a specified range (specified later)
5. Configure the Receive IP addresses and port numbers :
 If you selected: everyone on a specific UDP port (receive
broadcast) , type the UDP port number into the This is the UDP port I
want to receive data from: box
 If you selected: only specific IP addresses (receive unicast) , type
the IP addresses and port numbers into the
These are the IP
addresses I want to receive data from: text boxes
 If you selected: only a range of IP addresses (receive unicast
range) , type the ranges of IP addresses and port numbers into the
These are the IP addresses I want to receive data from: text boxes
6. Click
Save
Setting up Virtual COM (VCOM) Operation
When the Network Protocol is set to VCOM (Virtual COM Port) the serial
server communicates over the network with a PC, acting as a remote COM
port for the computer.