Cobalt Digital COMPASS 9229-QS Quad-Split Video Processor User Manual
Page 40

4-4
••••
Operation
9229-QS User Manual
••••
(V 1.2)
Use the following procedure to adjust the border of a quadrant source:
1.
Display the Device tab of the card by double-clicking its status indicator in the Basic
Tree View.
2.
From the Device tab, select the Quad Split tab.
3.
Select the Color/Border tab.
4.
Select the source you wish to configure a border for.
5.
Adjust the color of the border as follows:
•
Use the
Red
slider to adjust the amount of red that is mixed in the border of the
specified source. Note that 0 has no intensity, and 255 has full intensity.
•
Use the
Green
slider to adjust the amount of green that is mixed in the border of the
specified source. Note that 0 has no intensity, and 255 has full intensity.
•
Use the
Blue
slider to adjust the amount of blue that is mixed in the border of the
specified source. Note that 0 has no intensity, and 255 has full intensity.
6.
Use the
Trans
slider to adjust the transparency of the border, around the specified
source, from opaque (0%) to fully transparent (100%)
7.
Use the
Border
slider to adjust the thickness of the border in pixel units. Notice that as
you adjust the thickness of the border, it expands inwards from the edge of the quadrant.
A value of 0 removes the border. For best results, it is recommnded to increase the border
width in increments of 2 pixels.
This completes the procedure for adjusting the border of a quadrant source.