Signal loss alarm setup – Cobalt Digital COMPASS 9229-QS Quad-Split Video Processor User Manual
Page 29

9229-QS User Manual
••••
(V 1.2)
Configuration
••••
3-5
This completes the procedure for configuring the input signal timing for your 9229-QS.
Signal Loss Alarm Setup
The Signal Loss Alarm feature enables DashBoard to display status alarms when a loss of signal is
experienced on the Background input sources. The alarm information displays in the Signal tab of
DashBoard and on the card-edge LEDs. For more information on the status LEDs, refer to the section
“Card-edge LEDs”.
Use the following procedure to set up the Signal Loss Alarm feature:
1.
Display the Device tab of the card by double-clicking its status indicator in the Basic
Tree View.
2.
Display the Video tab as follows:
•
From the Device tab, select the Config tab.
•
Select the Video tab located at the bottom of the Config tab.
3.
Enable or disable the alarms by selecting or deselecting the required boxes in the Signal
Loss Alarm area as follows:
•
Bkgd A
— Select this box to enable DashBoard to report the status of the
Background A input source.
•
Bkgd B
— Select this box to enable DashBoard to report the status of the
Background B input source.
•
Bkgd C
— Select this box to enable DashBoard to report the status of the
Background C input source.
•
Bkgd D
— Selecting this box enables DashBoard to report the status of the
Background D input source.
This completes the procedure for setting up the Signal Loss Alarm.