Cobalt Digital COMPASS 9229-QS Quad-Split Video Processor - Manual (Page 20)

2-6 •••• Installation 9229-QS User Manual •••• (V 1.2)
• Slots 5, 6 • Slots 9, 10
3. (non-current) If you are installing the RM20-9229-QS-B Rear Module in a 20-slot frame
Cobalt Digital Inc. recommends installing the Rear Module in one of the following
combinations:
• Slots 5, 6, 7, 8 • Slots 13, 14, 15, 16
• Slots 9, 10, 11, 12 • Slots 17, 18, 19, 20
4. If you are installing the RM20-9229-C Rear Module in a 20-slot frame, Cobalt Digital
Inc. recommends installing the Rear Module in one of the following combinations:
• Slots 5, 6, 7, 8 • Slots 13, 14, 15, 16
• Slots 9, 10, 11, 12 • Slots 17, 18, 19, 20
5. Remove the Blank Plates from the rear of the selected card frame slots.
6. Seat the bottom of the Rear Module in the seating slot at the base of the backplane of the
frame.
7. Align the top holes of the Rear Module with the screw holes on the top-edge of the frame
backplane.
8. Verify that the 9229-QS aligns with the Rear Module before fully tightening any of the
slot screws.
9. Using a Phillips screwdriver and the supplied screws, fasten the Rear Module to the
backplane. Do not over tighten.
10. Install the supplied BNC label to the rear module.
11. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in the 20-slot frame.
Installing the Card
Use the following procedure to install the card in a 20-slot frame:
1. Ensure that the 20-slot frame is properly installed.
2. (non-current) If you are installing the 9229-QS in a DFR-8310 series frame, install the
card into an odd-numbered slot (e.g. slot 5, 7, or 9.
2. If you are installing the 9229-QS in a 20-slot frame and depending on the rear module
and slot combination you chose for the rear module, install the card into one of the
following slots:
ƒ RM20-9229-C Rear Module — Install the card in slot 6, 10, 14, or 18.
4. Hold the card by the edges and carefully align the card edges with the slots in the frame.
5. Fully insert the card into the frame until the card is properly seated in the Rear Module.